The metal connection pins between the wand and the floor head are dirty or misaligned.
Align the metal pins of the extension tube with the port on the main body. Push firmly until the mechanical latch clicks into place.
Plug the into a wall outlet and connect the charging pin to the battery's charging port.
Hold the vacuum over a trash can and press the located on the bottom of the canister. The flap will spring open to drop the dirt. Washing the Filters (HEPA & Stainless Steel Mesh) airbot hypersonic pro manual
A: Yes. The BMS (Battery Management System) stops charging once the battery reaches 100%, so overcharging is not possible.
Refer to pages 4-5 of the printed Airbot Hypersonic Pro manual.
Best for light dusting, hard floors, and maximum runtime (up to 45–50 minutes). The metal connection pins between the wand and
without the dust cup and filters properly installed in place.
Turn off the vacuum, remove the roller brush, cut away tangles, and clear the joint neck. Overheating protection triggered due to a severe blockage.
Press the power button again to turn the machine off. You do not need to hold the trigger down while cleaning. Switching Suction Modes Plug the into a wall outlet and connect
: Websites like Reddit, Quora, or specific forums dedicated to robotics or drones might have users who have experience with the device. They could provide valuable insights or direct you to a manual.
This often indicates the filters were put back while still damp. Remove and clean the filters and allow the unit to air out. Safety Precautions Do not use the vacuum to pick up liquids or wet debris. Avoid vacuuming hot ashes, glass shards, or sharp objects.
Unlatch the dustbin assembly from the main motor unit.
The LED display features a color ring that changes color based on the dust level: High dust concentration (maximum suction activated). Blue: Area is clean (suction decreases to save battery). 4. Charging and Battery Maintenance
