Canon G3400 Reset !!hot!!

Keep the ink flowing naturally to prevent the printheads from drying out and clogging.

Clearing Error 5B00 (Ink Absorber Full), logic board errors, and restoring all settings to default.

to lock itself once a specific volume of ink is projected to have been used.

The software will send a command, and the printer will print a sheet of paper with a line of text reading D=000.0 . This confirms the digital counter is successfully reset to zero. canon g3400 reset

Wait a few moments. The green light should now be glowing solid. This means your is officially in Service Mode! Step 2: Reset the Waste Ink Counter

Before pressing any buttons, you must understand what is happening inside your printer.

After refilling the tanks, the printer still shows ink as "Empty". You need to reset the waste ink counter or ink level memory. Keep the ink flowing naturally to prevent the

The Canon PIXMA G3400 is a workhorse known for its MegaTank ink system. However, like all printers, it can suffer from logic errors, stubborn "Error 5B00" messages, or connectivity glitches. Knowing how to properly reset the printer is an essential maintenance skill that can save you a service call.

Do not waste time looking for a "factory reset" button for error 5B00. It does not exist.

Complete Troubleshooting Guide: How to Reset the Canon PIXMA G3400 The software will send a command, and the

If you refilled the magenta, cyan, yellow, or black tanks but the printer still says "Low Ink," you don't need the Service Tool. You need a hard reset of the ink detection.

There are two types of resets that can be performed on the Canon G3400:

To understand this, it's helpful to know how your printer works. During print head cleaning cycles, maintenance, and routine printing, a small amount of ink is expelled to prevent clogs. This excess ink is channeled into a built-in "waste ink absorber pad" (sometimes colloquially called a "pampers") located at the bottom of the printer. Your printer meticulously tracks this ink usage using an internal counter.

When the internal "ink pad" counter is full, the printer locks itself. You can often bypass this manually without software by entering . Enter Service Mode : Turn off the printer. Hold the Stop button, then press and hold the Power button. While still holding Power, release the Stop button.