Caraflo V200 Shower Instructions Info

For a gravity-fed system, you must check that the supply pressure meets the minimum requirements. Also, to ensure the mixer works most efficiently, the operating pressures on both the hot and cold water lines should be balanced, and the incoming hot water must be at least 10°C above the desired final mixed temperature. If your water pressure exceeds 5 bar, you must install a pressure reducer before the mixer.

Debris, solder flux, and thread tape in the water lines can ruin the thermostatic cartridge. Flush both the hot and cold water supplies thoroughly before connecting the valve.

Choose a comfortable height for the mixer control interface. caraflo v200 shower instructions

Remove the chrome cover cap on the temperature control handle and unscrew the retaining screw to pull the handle off.

Unscrew the valve from the wall and clean the mesh filters. Check your water pump output. Unbalanced pressures or faulty cartridge For a gravity-fed system, you must check that

Caraflo V200 is a thermostatic shower mixer valve commonly used in static caravans and holiday homes. Below are instructions for its installation, use, and winter maintenance. Installation Instructions

Push the main Caraflo V200 valve body onto the mounting bracket or pipe tails. Debris, solder flux, and thread tape in the

Rotate the handle backward (counter-clockwise) until it hits the safety stop at 38°C.

Typically located on the left side of the valve.

The Caraflo V200 is typically designed for surface mounting against a shower wall cavity. Step 1: Prepare the Wall Cavity