Infineon Memtool 4.9 Access

Note: Memtool only supports ASCLIN interface for BSL communication—the professional version extends support to CAN interfaces as well .

Installing MEMTool 4.9 on modern Windows requires attention. Infineon’s distribution for v4.9 typically includes:

/erase : Wipes the defined memory sectors mapped by the active configuration.

Use Memtool 4.9 when you don’t need a debugger—only a reliable flash loader. infineon memtool 4.9

The firmware file contains addresses that do not exist on the selected MCU.

Connect your Infineon hardware (e.g., via miniWiggler ) to your PC and the target board. Open MemTool 4.9.

Here are some basic operations that can be performed with MemTool 4.9: Note: Memtool only supports ASCLIN interface for BSL

: Handles families including AURIX™ (TC2xx, TC3xx) , TriCore™ , XMC1000/XMC4000 , and legacy XC800/XC2000 series.

Open the Windows taskbar tray, find the DAS tool icon, and ensure the server is started. Alternatively, open a command prompt and run net start "DAS Server" . 2. "Device ID Mismatch"

If you encounter problems while using MemTool 4.9, try the following: Use Memtool 4

What (e.g., TC37x, XMC4500) are you targeting?

: It supports the onboard wiggler on Infineon evaluation boards and the external miniWiggler for custom hardware designs. Troubleshooting

Before installing MemTool 4.9, ensure that your system meets the following requirements:

If you’re happy and using only older XMC1k/4k devices, not really. But if you see:

Infineon Memtool 4.9 is a reliable, focused tool for those maintaining older Infineon microcontroller-based products. While obsolete for new AURIX development, it remains a valuable utility in the embedded engineer’s toolkit for legacy system support and production floor programming of XC2000/XE166 devices.