: Periodically check that the door moves without catching or swinging when manually released. If it feels heavy or unbalanced, the door springs may need professional adjustment.
The Life Probo PR70 Go to product viewer dialog for this item.
The PROBO series represents a family of irreversible electromechanical operators intended exclusively for automating residential-type sectional and up-and-over doors. This manual has been developed by the manufacturer, LIFE home integration, to serve as the primary reference for qualified installation and maintenance technicians, as well as for users. : Periodically check that the door moves without
Press and hold the button for 5 seconds . Release it when all indicator LEDs between the plus (+) and minus (-) markings illuminate continuously.
| Parameter | Value (PR70-07 / PR70-DL) | |-----------|---------------------------| | Mains power supply | 230 Vac 50 Hz | | Motor power supply | 24 V dc | | Max. power input | 260 W | | Max. input current | 8.5 A | | Input power to line (230V) | 1.2 A | | Thrust | 650 N | | Lubrication | Grease | | Encoder | Yes (built-in) | | Speed | 0.10 – 0.18 m/s | | Work cycles | 50% | | Nominal work time | 13 min | | Courtesy light | 24 Vdc (internal) | | Operating temperature | -20°C to +70°C | | Protection class | IP20 | | Motor insulation class | F | | Assembly | Horizontal ceiling-mounted on dedicated runner | | Dimensions (L×W×H) | 442 × 213 × 142 mm | | Weight | 6.7 kg | | Max leaf surface area | 11.5 m² | | Maximum door width | 5 m (for perfectly balanced doors) | The PROBO series represents a family of irreversible
Slide the protective cover cap (3) away from the heavy cast-aluminum base (7). Take care not to damage the rear plastic alignment tabs (4) during removal.
| Symptom | Possible cause | Fix | |---------|----------------|-----| | Pump runs but no flow | Air lock, blocked impeller | Re‑prime, clean impeller. | | Motor hums, not start | Capacitor failed, seized bearing | Test capacitor (µF), replace pump. | | Pressure fluctuates | Fouled pressure sensor, tank bladder failure | Clean sensor, replace tank. | | Overheating | Run dry, high ambient temp | Check water supply, improve ventilation. | | Fault code E04 | Dry run | Refill tank, reset controller. | Release it when all indicator LEDs between the
Centrally align the rail above the door and fix the omega brackets (8) to the ceiling.