Orbitor Prospector 100 Metal Detector Manual Jun 2026

Compress the pin and slide the lower shaft into the upper shaft.

Lower the Discrimination setting to search for broader metal types. 7. Safety and Maintenance Precautions

Usually indicates a solid object like a coin or ring.

Set the BATT.TEST/OPERATE switch (located on the underside of the control box) to the BATT.TEST position. The meter pointer should fall within the "good" or green range. If the needle points to the "replace" area, change the batteries before attempting to use the detector.

A: This indicates that the detector's internal circuit is stabilizing. The RESET button is designed to address this. Simply press and release the reset button after turning the device on to center the meter. Orbitor Prospector 100 Metal Detector Manual

Tighten the cable collar connector on the control box. Check battery voltage. Discrimination dial is set too high.

Plug the cable interface into the socket on the back of the control housing. Turn the outer ring clockwise to lock it in place. Control Panel Functions

The search coil is weather-resistant and can be used in shallow water or damp grass. However, the control housing is not waterproof . Keep the control box completely dry.

Lower the volume; increase discrimination; hunt away from power grids. Low battery voltage Check battery levels or replace the battery immediately. Intermittent signals Loose cable connection Compress the pin and slide the lower shaft

The spot where the sound peaks loudest and the meter jumps highest is the exact location of the target.

The official original manual for this specific model may be difficult to find online at general archives. However, several direct sources and alternatives can provide the necessary documentation:

: Tracks target feedback. A needle deflection to the left indicates small or trash objects; a right-side deflection indicates larger or highly conductive items. ⚙️ Initial Setup and Calibration

Slide open the battery compartment cover located on the underside of the control box. Safety and Maintenance Precautions Usually indicates a solid

Remove the batteries if storing the device for longer than 30 days to avoid corrosive leaks.

☑ Batteries are fresh and properly installed. ☑ Coil cable is snug against the shaft. ☑ Sensitivity and discrimination set according to site conditions. ☑ Detector is tuned to the ground (RESET performed and GROUND balanced). ☑ You have permission to search the area. ☑ You have the proper digging tool and a pouch for finds.

If you’ve recently acquired an , you are probably excited to start searching for buried coins, relics, gold, and silver. However, like any precision electronic instrument, this device performs best when you understand how to set it up, adjust its controls, and interpret its signals. While the original printed manual may be missing or difficult to locate, this comprehensive guide draws from official Prospector series documentation, user-tested field experience, and general metal‑detecting best practices to help you unlock the full potential of your Orbitor Prospector 100.