Place the laminator on a flat, stable, and heat-resistant surface. Ensure the exit path behind the machine is entirely clear. Plug the power cord into a wall outlet. 2. Thermal (Hot) Lamination
Before plugging in your device, ensure you place it in a safe environment to prevent overheating or electrical hazards. Initial Setup
: Wait for the green "Ready" lamp to illuminate before inserting any materials. 2. Hot Lamination Steps Select Pouch : Use 3-mil or 5-mil thermal pouches. staples 17466 laminator manual
A: No. This model supports only 3 mil and 5 mil pouches.
Periodically run a cleaning sheet or a folded piece of plain paper through the machine while hot to remove excess glue from the rollers. Safety Warnings Do not laminate empty pouches. Place the laminator on a flat, stable, and
Wipe the exterior plastic housing with a dry microfiber cloth only after the machine is unplugged and fully cool. What (3-mil or 5-mil) are you using? Is the Ready light turning on successfully?
: If you are doing both hot and cold lamination, do the cold setting first to avoid waiting for the machine to cool down. 4. Troubleshooting & Maintenance Place the laminator on a flat
Gently guide the pouch into the slot until the motorized rollers take hold.
Adhesive residue can build up on the internal rollers over time. To clean: