Strands S68 - Drill Press Manual
| Interval | Task | |----------|------| | | Wipe down column and table; remove metal chips and dust. Check belt for fraying. | | Weekly | Lubricate the quill rack and pinion gear with light machine oil (ISO VG 32). | | Monthly | Apply grease to the depth stop thread. Lubricate table tilt bevel gears. Check/replace belt. | | Every 6 months | Remove motor and blow out dust from head housing. Oil the spindle pulley bearings (high-temp grease). | | Annually | Check and adjust spindle bearing preload (complex – refer to manual drawings). Clean and re-grease return spring housing. |
Typically equipped with a 2-speed, 3-phase industrial motor. Understanding the Geared Head and Speed Selection
The main spindle bearings are sealed and lubricated for life on most S68 variants. If you notice grinding noises, the bearings must be pressed out and replaced. 5. Troubleshooting Common Issues Probable Cause Recommended Solution Excessive Gearbox Noise Low oil level or incorrect oil viscosity. Top off or change oil using ISO VG 68 gear oil. Spindle Slips/Stops Under Load Gear levers are not fully engaged. Strands S68 Drill Press Manual
Proper lubrication is the single most important factor in the longevity of any machine tool. According to a user who has access to the manual, the lubrication schedule is quite specific:
| Issue | Possible Cause | Solution | | :--- | :--- | :--- | | | Dirty spindle taper or chuck. | Remove the chuck/arbor, clean tapers with a dry cloth (no oil), and reseat firmly. | | Motor hums but won't start | Faulty capacitor or 3-phase issue. | Check electrical connections; if using a static converter, ensure it is sized correctly. | | Hard to shift gears | Gears under load or debris in linkage. | Ensure machine is off. Rock the chuck by hand slightly to align teeth. | | Noisy operation | Low gearbox oil. | Check oil level immediately. Top up if low. | | Interval | Task | |----------|------| | |
A full manual would have several critical sections. Here’s a practical guide to those topics for the Strands S68:
For maximum precision, bolt the Strands S68 to a flat, vibration-dampening concrete floor. Use precision machinist levels on the machined base plate. Use steel shims under the mounting feet until the column stands perfectly vertical at 90 degrees relative to both the X and Y axes. 2. Electrical Connections | | Monthly | Apply grease to the depth stop thread
Disclaimer: This article provides a general overview based on available public documents. Always refer to the specific manual provided with your machine, as specifications may vary by model year.
Utilizes the standard three-spoke handwheel on the right side of the head.
Place the drill press on a level concrete floor. For maximum accuracy and vibration dampening, bolt the base to the floor using standard anchor bolts. Electrical Connections