Click to clear the drive. (Note: This deletes all data on the USB).
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Choose USB Upgrade or HTTP Upgrade path.
Disclaimer: This content is for educational purposes. We are not responsible for any damage caused by unauthorized software updates.
Transfer the raw .bin file directly to the USB root directory. Do not place it inside folders. 🔌 Step 3: Install the Software via USB
: Formatted to FAT32 for maximum compatibility.
: Locate the firmware file specifically for your model. Common Supermax software files often end in .bin or .abs .
Insert the drive into the USB port on the front or back of your Supermax receiver.
It is highly recommended to perform a factory reset after a firmware update to ensure the new software runs smoothly. Go to > Tools > Factory Reset .
Plug the USB drive into the USB port located on either the front or back of the receiver.
Look on the back or in the menu: Menu → System Information → Model / Software Version
: Always ensure you are using the correct software for your exact model to avoid "BOOT" problems or bricking the device.
| Problem | Likely Cause | Solution | | :--- | :--- | :--- | | "USB device not found" | USB not FAT32; drive too large; not inserted before boot | Reformat to FAT32; use a 4GB drive; plug in BEFORE turning on receiver. | | "File mismatch error" | Wrong firmware for your model/hardware version | Double-check your model number. Download a different version. | | Receiver stuck on "boot" | Corrupted update or power loss during flash | Re-attempt Method B (force flash) with the correct flash.bin file. | | Remote not working after update | Firmware changed remote code set | Unplug receiver for 10 minutes; try original remote; or use a universal remote. | | No signal after update | LNB settings reset to default | Re-enter your LNB Type and DiSEqC settings. Run a new blind scan. |
Select AllCode or Software mode for complete updates.