Thyssenkrupp Levant Stair - Lift Installation Manual Fixed
The charger is installed, which will constantly recharge the battery. 5. Installing the Seat and Safety Sensors The chair is mounted onto the carriage.
If you encounter any mechanical failures or error codes not covered in this guide, consult a certified ThyssenKrupp accessibility technician to avoid voiding your warranty or compromising user safety.
Before unboxing the equipment, you must verify that the staircase and the surrounding environment meet the minimum technical specifications required for the Levant model. Dimensional Constraints
Verify that the carriage slows down smoothly and stops automatically at the terminal charging points. thyssenkrupp levant stair lift installation manual
Are you looking to install this yourself, orKnowing this will help you get the best guidance. Lifeway Mobility Stair Lift Installation - Lifeway Mobility
Regular, annual maintenance by a qualified technician is highly recommended to inspect electrical components and mechanical wear.
Wireless infrared or radio-frequency handheld controllers. 3. Step-by-Step Installation Procedure Step 1: Laying Out and Joining the Rail The charger is installed, which will constantly recharge
Included in the installation kit, but a standard metric set is useful.
Plug the seat wiring harness into the corresponding port on the carriage control board. This connects the seat belt sensor and armrest controls to the main processor. 5. Wiring and Electrical Configuration
: Minors or those with mental handicaps should only use the device under supervision [1]. If you encounter any mechanical failures or error
Lay the rail sections face-down on a protected flat surface parallel to the staircase.
The lift is plugged into the power supply to charge the batteries before the first run. Step 5: Final Adjustments and Safety Checks
Set the entire rail assembly onto the stairs. Use your tape measure to ensure the rail runs perfectly parallel to the wall or banister. The manual specifies a minimum clearance distance (typically around 5 inches from the wall) to allow room for the carriage and seat mechanism. Step 4: Securing the Brackets
Check the tightness of all mounting bracket screws on the stairs.
