The Intel UHD Graphics 770 cannot be used in any Hackintosh build under any known configuration. macOS lacks drivers for this iGPU, and no community solution exists to enable it. The last natively supported Intel integrated graphics belong to the 10th generation Comet Lake processors.
If you are planning a Hackintosh build around a modern Intel CPU, understanding the limitations and workarounds for the UHD 770 is critical. The Core Issue: Does macOS Support UHD 770?
| Component | Recommendation | |---|---| | CPU | Intel 12th/13th/14th gen (K or non-K) — any model works; you are paying for CPU performance, not iGPU | | GPU | Supported AMD card (see table above) | | Motherboard | Z690, B660, or Z790 chipset from documented compatible models | | RAM | DDR4 or DDR5 — both work; choose based on motherboard support | | Storage | NVMe SSD (Samsung, WD, Kingston are common choices) | | Power Supply | Sufficient wattage for your dGPU (e.g., 650W+ for RX 6800) |
If you forget to disable the iGPU and macOS installs but boots to a low-resolution desktop or constantly loops back to the login screen, you have entered the "no acceleration" zone. To fix this: uhd 770 hackintosh
If not configured correctly, you may see only 7MB or 14MB of VRAM and no hardware acceleration.
Intel UHD 770 is built on the Intel Xe architecture. This architecture is fundamentally different from the older Intel UHD 630/640 series found in supported 9th and 10th Gen Intel CPUs. Because Apple never wrote drivers (Kexts) for the Intel Xe graphics architecture, macOS has no blueprint for communicating with the UHD 770 chip.
Getting Intel UHD Graphics 770 (found in 12th-14th Gen Intel Alder Lake/Raptor Lake CPUs) working on a Hackintosh is technically possible but requires spoofing an older supported GPU because macOS does not natively support Xe architecture graphics. The Intel UHD Graphics 770 cannot be used
In your OpenCore config.plist , under DeviceProperties -> Add , you must set up your IGPU ( PciRoot(0x0)/Pci(0x2,0x0) ) with the following settings:
Final Cut Pro, Adobe Premiere, Photoshop, and Xcode will either run poorly or fail to launch.
It is highly recommended to lower SIP to allow the OCLP patches to work. In config.plist , go to NVRAM -> Add -> 7C436110-AB2A-4BBB-A880-FE41995C9F82 : If you are planning a Hackintosh build around
Enter the . This is the iGPU found on most desktop Alder Lake-S and Raptor Lake-S chips (excluding the F-series). For Windows users, it’s a decent media engine. For macOS users? It has historically been a wall of frustration.
Before installation, configure your BIOS as follows:
If you have not purchased your hardware yet and want to avoid buying a dedicated graphics card, look back one generation: