Viva Water Dispenser Manual 8liech-sc-ssd =link= -

The unit injects ozone into the water tanks and lines to kill bacteria and biofilm.

Check that the bottle is not damaged and the probe is sitting flat.

on how to safely sanitize the internal tanks without leaving a vinegar aftertaste? USER MANUAL viva water dispenser manual 8liech-sc-ssd

| Problem | Possible Cause | Solution | | :--- | :--- | :--- | | | Air lock in tank. | Remove the bottle and re-install it. Press the taps to release air bubbles. | | Water is not cold | Power cord unplugged. | Check the power connection. | | | Cooling switch is off. | Ensure the green switch on the back is ON. | | | Water is being used frequently. | Wait 10-15 minutes for the tank to re-cool. | | Water is not hot | Heating switch is off. | Ensure the red switch on the back is ON. | | | Thermal cut-out tripped. | Unplug for 10 mins, then plug back in. | | Dispenser is noisy | Compressor vibrations. | Ensure the unit is level on the floor. Check for loose parts. | | Leaking water | Bottle crack or loose seal. | Check the water bottle for cracks. Ensure it is seated correctly. |

Your 8LIECH‑SC‑SSD is equipped with an system. When the Self Clean cycle runs, the dispenser injects a controlled, low level of ozone (≤ 50 ppb) into the water tank. This ozone destroys bacteria and viruses, prevents biofilm build‑up, and protects the original quality of the bottled water without altering its mineral content or taste. The unit injects ozone into the water tanks

Injects ozone every 4 hours to kill bacteria and prevent biofilm buildup. This reduces manual maintenance, though external nozzles still require periodic cleaning.

Place the dispenser vertically on a stable floor. Wait 30 minutes before plugging it in if the unit was transported horizontally. This allows the compressor oil to settle. USER MANUAL | Problem | Possible Cause |

The 8LIECH-SC-SSD features an intuitive interface with safety mechanisms for the hot water function.

Place the unit on a hard, flat, level floor. Leave a minimum of 4 inches of clearance on the back and all sides to allow free airflow and minimize vibrations. Do not store the unit inside an enclosed cabinet or in direct sunlight. First-Time Setup and Bottle Installation 8LIECH-SC-SSD

| Specification | Detail | |---|---| | | 8LIECH-SC-SSD | | Type | Self Clean Bottom Loading Water Cooler | | Voltage Options | 120V/60Hz or 220V/50~60Hz | | Heating Power | Up to 650W | | Hot Water Output | 6L / 1.59 gallons per hour (≥80°C/176°F) | | Cold Water Output | 4L / 1.06 gallons per hour (≤10°C/50°F) | | Hot Tank Volume | 1.2L / 0.32 gallons | | Cold Tank Volume | 4L / 1.06 gallons | | Product Dimensions | 38.2 × 32 × 102.8 cm (15.0 × 12.6 × 40.5 inches) | | Refrigerant | R134a | | Compressor Power | 70W (max <100W) | | Weight | Approximately 34.6 pounds | | Certifications | CE, CSAus, CB | | Loading Capacity | 192 units per 20 GP container / 396 units per 40 GP container |