Weltouch Cy-210b Manual Jun 2026

: Supports multiple weld schedules (often up to 15 in similar Weltouch models) to handle different welding tasks. amada weld tech Wiring for Dual-Level Foot Switch According to the official addendum amada weld tech : Connect one wire to and the other to (Start 1 schedule). : Connect one wire to (common) and the other to Verification

The you are resistance welding (e.g., high-tensile steel, galvanized iron).

Installation and repair should only be performed by qualified personnel. weltouch cy-210b manual

A typical weld sequence has a 20ms delay (60ms max) after the start signal before welding begins. If the start signal is cut before the hold period, the T2 timer defaults to 200ms. amada weld tech Technical Documentation

Your desired in kA.

| Setting | Option | Description | | :--- | :--- | :--- | | | Glove / Bare finger | Increase sensitivity for thick gloves (Active for 30 sec after wake). | | Water Rejection | On / Off | Filters out false touches from water droplets on screen. | | Edge Filter | 5px – 30px | Disables touches within X pixels of screen edge (for bezel interference). | | Beep on Touch | Enabled | Requires internal buzzer (not available on all revisions). | | Rotation | 0 / 90 / 180 / 270 | Rotates touch coordinates to match display orientation. |

: Set the post-weld consolidation period. Keep the electrodes closed while the molten copper-alloy or steel joint solidifies. DIP Switch Configurations (DSW1) : Supports multiple weld schedules (often up to

While the CY-210B is discontinued, replacement units and parts can still be found. offers a used CY-210B with a 2-year warranty. Their repair facility can diagnose and repair controllers.

Identify the four wires from your foot switch: two for Level One and two for Level Two. Installation and repair should only be performed by